AUM 23 stainless steel waterfall tap

The AUM 23 tap is an automatic wash basin waterfall tap with contactless control, with one water connection (cold or pre-mixed water), two water connections (hot and cold), or two water connections with thermostatic valve. Thermostatic valve is located under the basin, the temperature is set by the owner, the user cannot change the setting.

By putting your hands in the basin (into the sensor zone under the outlet arm) you activate the control electronics, which is indicated by flashing of the sensor indicator, and the electromagnetic valves are opened immediately. If you remove your hands from the basin, the indicator goes out and the electromagnetic valves are closed and water stopped with a sufficient time delay. If the shading is permanent, the valves shut the water after 30 s. With the battery versions, the electronic program ensures that the electromagnetic valve does not open the water inlet unless the battery capacity is sufficient for its shutting.

The AUM 23.xx tap is supplied with 12 V, 50 Hz from source of power supply ZAC.
The AUM 23.xxB tap is supplied with direct voltage 6 V from AA batteries mounted under the basin.

ZAC – source of power supply 12V, 50Hz

Radius of sensor automatically adjusted
Power supply 12 V, 50 Hz (AUM 23.xx)
6 V DC (AUM 23.xxB)
Power requirement 6 VA
After-flow period 0 – 4 s (set by producer to 1 s)
Time of water flow (Start/Stop function) 5 – 100 s in 5 s steps (set by producer to 15 s)
Water pressure 1 - 10 Bar (AUM 23.xx)
2 - 8 Bar (AUM 23.xxB)
Diameter of installation opening in washbasin min. 33 mm, max. 38 mm
Recommended source of power supply ZAC 1/23 (max. 3x AUM 23.xx)
ZAC 1/50 (max. 8x AUM 23.xx)
ZAC 1/36L (max. 6x AUM 23.xx)
Battery supply - 6V (4x 1,5 V) (AUM 23.xxB)
  • Set-up water inlet - G 1/2"
  • Set-up cable for power supply – 12 V, 50 Hz from source of power supply ZAC (does not apply to AUM 23.xxB)


Data for projectants